jet engine thomas project

26 Replies, 6691 Views

Or just simply swap the shell. Usually the shell can be used on different chassis.
My Trackmaster/Tomy/Plarail Photo Gallery Page (over 600+ photos and still under construction)
https://www.flickr.com/photos/183311600@N03/
can't do that, it still won't be fast
dreaming of piles of track 
(This post was last modified: 05-05-2022, 05:14 PM by Super.)
(05-05-2022, 03:59 PM)stainedgaming Wrote: how many volts is jet engine thomas motor?

If it just uses one AA or one C battery then its 1.5 volts
[Image: super-smiley-emoticon.gif]
should i go 2 volts or 2.5 volt motor?
dreaming of piles of track 
[-] The following 1 user Likes stainedgaming's post:
  • Super
No, actually you have that backwards..when using a 1.5 volt battery you need a 1.5 volt motor. A motor needing a higher voltage will not increase your speed...it may even decrease it as it would need more volts than the battery will give it. Take a look at this former members motor comparison video and a couple from our Host Ucwepn.



[Image: super-smiley-emoticon.gif]
so what you're saying voltage doesn't matter?
if so then thank god
i don't have the skills to put a 9v battery in lol

anyways, would this be a good 25000 rpm motor?
https://www.amazon.co.uk/X-DREE-Electric...49&sr=8-27
dreaming of piles of track 
[-] The following 1 user Likes stainedgaming's post:
  • Super
All the engines in the Linked videos have motors that use 1.5 volts from a AA battery.

Thats a 12 volt motor Stain. What country are you in to see if we can locate something for you.
[Image: super-smiley-emoticon.gif]
@Stain
Check your Private Messages
[Image: super-smiley-emoticon.gif]
so if i get this motor, i don't need to fit bigger battery?
just checked the speed of light dash, would prefer 25000rpm motor if possible?
dreaming of piles of track 
(This post was last modified: 05-06-2022, 03:53 PM by Super.)
Then you might want to try these inexpensive ones from Amazon...in this video from Custom Trackmasters
[Image: super-smiley-emoticon.gif]



Users browsing this thread: 2 Guest(s)